Black Faux Leather Multi-Strap Chest Harness with Rivets

This black faux leather chest harness is built around a structured Y-frame silhouette with two horizontal band straps running across the chest and mid-torso, each secured by silver-tone rivet studs. The geometry is deliberate — not a single crossover band but a layered cage effect that sits flat and stays in position without constant adjustment.

Chest Strap Construction

The harness uses a Y-shaped shoulder bridge that splits from a central front connector, fanning across both pecs before meeting the dual horizontal bands. Each strap is approximately 1.5 cm wide, maintaining visual presence without bulk. Silver metal rivets at every junction add structural reinforcement and a raw industrial edge that pairs with both minimal and layered outfits.

• Dual horizontal bands span the full chest and upper abdomen
• Y-frame shoulder bridge with a single central front anchor point
• Silver-tone rivet hardware at every strap crossing and adjustment point
• Approximately 1.5 cm strap width — bold enough to read under a sheer shirt
• Flat-lay profile sits flush against the torso without gapping

Sizing and Fit

Adjustable buckles on both the shoulder straps and the horizontal bands allow a chest range of roughly 80 cm to 115 cm, covering XS through XL body types comfortably. Larger builds above 120 cm chest may find the horizontal bands sit higher than intended. The harness is cut to sit mid-chest, not full-body, so it stops above the navel — check the torso length if you want coverage past the ribcage.

• Adjustable chest range: approximately 80–115 cm
• Shoulder strap length: individually adjustable at the back buckle
• Harness length from shoulder to lower band: approximately 35–40 cm depending on adjustment
• Trade-off: chest sizes above 120 cm may experience limited band reach at the lower strap

Material and Care

Constructed from smooth-finish black faux leather (PU-coated fabric), the straps are firm enough to hold their shape without a stiff break-in period. The silver hardware is zinc alloy — rust-resistant for everyday wear but avoid prolonged water exposure. Wipe clean with a dry or slightly damp cloth; do not submerge, machine wash, or iron.

• Body: smooth black PU faux leather, no visible grain texture
• Hardware: zinc alloy silver-tone rivets and buckles
• Care: wipe with damp cloth only — not machine washable
• Avoid prolonged direct sunlight to prevent PU surface cracking

Styling and Occasion

The double-band body cage reads clearly over a white mesh tank for a festival harness look, or wear it directly over skin under an open button-down for a streetwear night-out outfit. At raves, the silver rivets catch light against a bare chest. It also layers cleanly under a structured blazer with the straps visible at the neckline — a fashion harness detail that works without a full costume commitment.