Black Faux Leather Cage Harness with Thigh Cuff Bands

This black faux leather cage harness delivers a fully structured silhouette from collar to thigh, built around five horizontal waist straps, a framed chest section, and dual thigh cuff bands that wrap the upper leg in layered 1.5 cm wide strips. It layers over sheer tops, mesh sets, or bare skin — the multi-strap torso cage reads as a garment in its own right, not a finishing accessory.

Strap Construction and Hardware

Every strap on this body cage harness is cut from smooth black faux leather with a matte finish and reinforced at each join with gold-tone metal studs and adjustable pin-buckle closures. The chest frame anchors at a collar ring, crosses at the sternum, and branches into two parallel bands that enclose the ribcage. Below the waist, five stacked horizontal straps tighten independently, giving a custom cage fit across a wide range of torso lengths.

• Gold-tone pin-buckle hardware on every strap — no snap closures that pop under movement
• Collar-to-hip coverage spans approximately 45-60 cm depending on torso length
• Thigh cuff section features four stacked bands per leg connected by vertical side rails
• Strap width: 1.5 cm throughout for a consistent cage geometry
• Total adjustable range accommodates waists from approximately 60-110 cm

Thigh Cuff Styling and Occasions

The thigh cuffs are the defining feature that separates this from a standard chest harness: they extend the cage architecture down the leg, making it work as a full festival harness outfit layer or a rave outfit harness worn over sheer bodysuits. Pair with high-waisted trousers and an unbuttoned shirt for a streetwear look where only the collar and chest section show, or wear over a bodysuit for a full fashion harness effect at a party or editorial shoot.

• Layer over a white sheer corset or bodysuit for a high-contrast editorial look
• Wear with wide-leg trousers — cuffs visible below the hem create a two-zone styling effect
• Festival harness base layer: attach to a mesh top for a rave outfit harness with structured depth
• Studio or creative shoot: the gold hardware photographs well against pale or neutral backgrounds

Sizing and Fit Notes

This harness set is designed for a range of body types; sizes run XS through 7XL with each strap adjustable by at least 8 cm. The chest frame fits best on torsos with a chest circumference of 75-130 cm; at the extreme upper range the horizontal straps will sit closer together. The thigh cuff bands are most comfortable on thighs measuring 45-70 cm in circumference — wearers above 70 cm should size up and use the buckles at their widest setting. Note that because every adjustment is manual via individual buckles, putting on the full harness takes roughly 3-5 minutes; plan accordingly before an event.

Material and Care

The straps are made from smooth vegan faux leather over a polyurethane base, which gives the matte black finish visible in the image. Hardware is zinc-alloy with a gold-tone plating. Faux leather does not breathe the way woven fabric does, so this harness is best suited for 2-4 hour wear sessions in cooler or air-conditioned environments. Clean with a damp cloth and mild soap only — do not submerge in water, do not machine wash, and store flat or rolled to avoid crease marks on the strap surface. Avoid prolonged direct sunlight, which can fade the gold-tone plating over time.