Black Faux Leather Y-Strap Harness with Triple O-Rings

This black faux leather chest harness runs a single vertical Y-strap from a fitted choker collar down the center of the chest, linking three stacked silver-tone O-rings at the throat, mid-chest, and sternum with studded rivet connectors. The slim strap width of approximately 1.5 cm keeps the silhouette minimal while the hardware stays bold — a deliberate contrast that reads as fashion harness rather than sportswear.

Festival and Streetwear Styling

Worn over a plain black tee or open-button shirt, the vertical O-ring column extends the visual line of the torso. For festival looks, layer it over a mesh long-sleeve top so the rivet detail catches light without competing with patterned fabric. As a streetwear chest harness, it sits cleanly under a blazer with the collar ring just visible above the lapels — the rave outfit harness read disappears entirely, leaving only edge.

• Layer over a fitted black turtleneck for a winter festival chest harness look
• Pair with a sleeveless vest and high-waisted trousers for a rave outfit harness finish
• Style under an unbuttoned shirt for an understated fashion harness detail

Sizing and Adjustable Fit

The choker neck strap and the connecting Y-strap are both adjustable via studded buckles, accommodating chest circumferences from roughly 76 cm to 140 cm — covering XS through 7XL. The single central strap means there are no side panels to size: if the adjustable buckle can cinch or extend to sit flat against the sternum, the fit is correct. Note: the Y-strap design covers only the center chest line — buyers expecting full chest coverage or side straps should consider a cage-style body harness instead.

• Adjustable choker collar fits neck circumferences from approximately 32 cm to 44 cm
• Central Y-strap adjusts from roughly 30 cm to 55 cm in total drop length
• Flat silver rivet studs at each connector point, diameter approximately 0.8 cm
• Single-strap profile: best for slim-to-athletic chest frames; no lateral structure

Material and Hardware Care

The strap body is faux leather (PU-coated synthetic), which resists surface scuffs better than fabric but should not be submerged in water or machine washed. The three O-rings and rivet hardware are silver-tone zinc alloy. Wipe the faux leather with a barely damp cloth and pat dry; a very light application of PU conditioner every few months prevents cracking at the buckle fold points. Avoid prolonged exposure to direct heat — the PU coating can warp near radiators or in a hot car.

• Body material: PU faux leather, approximately 1.5 cm wide straps
• Hardware: silver-tone zinc alloy O-rings, three total, and flat rivet studs
• Care: wipe clean with damp cloth; no machine wash, no soaking
• Storage: hang flat or roll loosely to prevent crease marks at buckle points