X-Back Black Faux Leather Body Harness with Silver O-Ring

This X-back body harness is cut from black faux leather straps finished with silver-tone hardware, built to layer over t-shirts, bodysuits, or bare skin as a strappy harness accent. Two front straps run over the shoulders and cross at a single silver O-ring between the shoulder blades before splitting into a lower X pattern at the back. Unlike wider webbing-style harnesses, the straps here hold close to 1 cm wide for the full length, so they sit flat against fabric instead of twisting or rolling during wear.

Adjustable X-Back Straps

Slide buckles at both shoulders let you shorten or loosen the strap run without punching new holes, which matters for a body cage style that has to sit the same way on different torso lengths. The O-ring itself does not move once the straps are set, since it is fixed at the point where four straps meet, and two smaller connector rings below it keep the lower X from twisting out of place while you move.

• Two shoulder straps cross into a single silver O-ring at the upper back
• Slide buckles at the shoulders adjust strap length for a fitted body cage
• Strap width stays close to 1 cm from the shoulder down to the lower rings
• Two smaller connector rings link the lower straps into the finished X shape
• Silver-tone rivets reinforce each strap intersection instead of stitched seams alone

Styling & Occasion

Worn over a plain tank top with high-waisted denim, the harness reads as daytime streetwear rather than a going-out piece. Layered over a slip dress or bodysuit with combat boots, the same straps turn into festival harness or rave outfit styling for a night set. Because the straps sit outside the garment, the fashion harness look stays visible under a jacket left open at the front, and the same X-back shape works over a plain white tee for a simpler everyday chest harness moment.

Sizing & Fit

This strappy harness comes in six labeled sizes: XS/S, S/M, L/XL, 2XL/3XL, 4XL/5XL, and 6XL/7XL, covering narrow frames through plus size bodies without a separate plus line. Shoulder buckles add roughly 5 cm of adjustment on each side, but the O-ring drop height is fixed, so the harness will not sit noticeably lower or higher than the labeled size allows regardless of buckle setting.

• XS/S and S/M fit narrower shoulders and a smaller chest measurement
• L/XL suits average to fuller busts with buckles set mid-range
• 2XL/3XL through 6XL/7XL extend the same o-ring harness cage to plus size proportions

Material & Care

The body of the harness is faux leather (vegan leather), not fabric webbing, paired with silver-tone metal rings and buckles at every strap junction. Faux leather does not stretch out the way elastic webbing does, so the strap width holds its shape after repeated wear, though it can crease permanently if folded tightly for storage rather than hung. The hardware is metal rather than plastic, which adds a small amount of weight at the O-ring but also means the connector rings will not crack the way molded plastic rings can over time.

• Material: faux leather straps with silver-tone metal hardware throughout
• Wipe clean with a damp cloth rather than washing in a machine
• Hang or lay flat to keep the buckle folds from creasing
• Avoid prolonged sun exposure, which can dull the faux leather finish over time